LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> F-150 Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Electronic Engine Controls System - 5.0L 32V Ti-VCT) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal

Manifold Absolute Pressure (MAP) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Remove the intake manifold. Refer to: Intake Manifold .

  1. 2.

    Remove the retainer and MAP sensor.

    Torque: 53 lb.in (6 Nm)

GFD41277Courtesy of FORD MOTOR COMPANY