Intake Manifold Runner Control (IMRC) Solenoid: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Remove the intake manifold. Refer to: Intake Manifold .
- 2.
- Disconnect the 6 vacuum hoses from the IMRC solenoids, remove the 3 retainers and the solenoid mounting plate.
Torque: 53 lb.in (6 Nm)
- Remove the 2 retainers and remove the IMRC solenoids.
Torque: 71 lb.in (8 Nm)
- Disconnect the 6 vacuum hoses from the IMRC solenoids, remove the 3 retainers and the solenoid mounting plate.