LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> F-150 Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Electronic Engine Controls System - 5.0L 32V Ti-VCT) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal

Crankshaft Position (CKP) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Remove the RHF wheel and tire. Refer to: Wheel and Tire .

  1. 2.

    Remove the RH fender splash shield. Refer to: Fender Splash Shield .

  1. 3.

    Disconnect the CKP sensor electrical connector, and harness retainer from stud.
GFD41263Courtesy of FORD MOTOR COMPANY

  1. 4.

    Remove the bolt and the CKP sensor.

    Torque: 89 lb.in (10 Nm)

GFD41264Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals