Transmission Fluid Heater Coolant Control Valve: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.WARNING: When releasing the cooling system pressure, cover the coolant expansion tank cap with a thick cloth.
Loosen the pressure relief cap.
- 2.
- 1.
Using a general tool, clamp both coolant hoses. Use the General Equipment: Locking Pliers
- Release the hose clamps and disconnect the coolant hoses. Use the General Equipment: Hose Clamp Remover/Installer
- Disconnect the electrical connector.
- 1.
- 3.
Using a suitable tool, release the retaining clip and remove the transmission fluid heater coolant control valve.