Cooling Fan Motor and Shroud: Removal
WARNING: This page is about a different variant/trim than selected.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- 2.
Position aside the coolant tube. Disconnect and position aside the brake booster and the crankcase ventilation tubes. Loosen the clamp and remove the retainers and the air cleaner and outlet pipe assembly.Torque:
Clamp:: 36 lb.in (4.1 Nm)
Bolt:: 155 lb.in (17.5 Nm)
- 6.
Detach the pin-type retainers and harness retainer that secure the wiring harness to the cooling fan shroud.
- 9.
Lift the cooling fan motor and shroud upward and place wooden block to support it. Detach the pin-type retainers that secure the lower radiator shield to the cooling fan shroud. Use the General Equipment: Wooden Block