Ignition Coil-On-Plug: Removal

WARNING: This page is about a different variant/trim than selected.

1.

Remove the engine appearance cover retainers and then remove the engine appearance cover.

GFD40885

Courtesy of FORD MOTOR COMPANY

2.
- 1.
  
  Detach the LH ignition coil-on-plug harness retainers from the ignition coil-on-plug studbolts.
- 2.
  
  Slide the red locking tab (CPA) back away from the ignition coil-on-plug, depress the latch and then remove the connector from the ignition coil-on-plug.

GFD41108

Courtesy of FORD MOTOR COMPANY

3.
- 1.
  
  Disconnect the RH CMP sensor electrical connectors.
- 2.
  
  Detach the RH ignition coil-on-plug harness retainers from the ignition coil-on-plug studbolts.
- 3.
  
  Detach the RH ignition coil-on-plug harness retainer from the valve cover studbolt.
- 4.
  
  Slide the red locking tab (CPA) back away from the ignition coil-on-plug, depress the latch and then remove the connector from the ignition coil-on-plug.

GFD41109

Courtesy of FORD MOTOR COMPANY

4.

NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removal.

NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
- 1.
  
  Remove the ignition coil-on-plug studbolts.
- 2.
  
  Remove the ignition coil-on-plugs.

GFD41110

Courtesy of FORD MOTOR COMPANY