Crankshaft Position (CKP) Sensor: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- 2.
- If equipped, remove the bolts.
- Release the retainer and remove the transmission housing cover.
Torque: 71 lb.in (8 Nm)
- 3.NOTE: Vehicles come with an underbody shield or a skid plate.
- If equipped, remove the bolts and the pin-type retainers.
- Remove the bolts and the underbody shield.
Torque: 30 lb.ft (40 Nm)
- 4.NOTE: Vehicles come with an underbody shield or a skid plate.
If equipped, remove the bolts and the skid plate.
Torque: 30 lb.ft (40 Nm)
- 7.NOTE: Remove the bolt and the CKP sensor from the bell housing before disconnecting the electrical connector to prevent the CKP sensor from falling in the bell housing.
Remove the bolt, disconnect the CKP sensor electrical connector and remove the sensor.
Torque: 89 lb.in (10 Nm)