Turbocharger Oil Supply Tube RH: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
Install the new TC oil supply tube O-ring seals and the new TC oil supply tube oil filter. Lubricate the new TC oil supply tube O-ring seals with clean engine oil.Material: Motorcraft ® SAE 5W-30 Premium Synthetic Blend Motor Oil / XO-5W30-QSP (WSS-M2C946-A)
- 2.
Install the TC oil supply tube, then install and tighten the TC oil supply tube bolts.Torque: 89 lb.in (10 Nm)
- 3.
Install the A/C compressor, install and tighten the A/C compressor mounting bolts.Torque: 18 lb.ft (25 Nm)
- 4.
Install the Accessory Drive Belt. Refer to: Accessory Drive Belt .
- 5.
Install the RH CAC intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
- 6.
Install the Air Cleaner Outlet Pipe RH. Refer to: Air Cleaner Outlet Pipe RH .
- 7.
Install the RHF fender splash shield. Refer to: Fender Splash Shield .
- 8.
If equipped, install the skid plate or splash shield, then install and tighten the bolts.Torque: 30 lb.ft (40 Nm)
- 9.
If equipped, install the transmission housing cover, then install and tighten the retainers.Torque: 71 lb.in (8 Nm)
- 10.
Install the engine appearance cover and then install and tighten the engine appearance cover retainers.Torque: 42 lb.in (4.8 Nm)