Turbocharger Coolant Supply Tube RH: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Whenever turbocharger air intake system components are removed, always cover open ports to protect from debris. It is important that no foreign material enter the system. The turbocharger compressor vanes are susceptible to damage from even small particles. All components should be inspected and cleaned, if necessary, prior to installation or reassembly.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- 3.NOTE: Vehicles come with a skid plate or a splash shield.NOTE: Skid plate shown, splash shield similar.
If equipped, remove the bolts and the skid plate or splash shield.
- 4.
Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .
- 5.
Remove the RHF fender splash shield. Refer to: Fender Splash Shield .
- 6.
Remove the air cleaner outlet pipe RH. Refer to: Air Cleaner Outlet Pipe RH .