Turbocharger Coolant Supply Tube RH: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Install the new TC coolant supply tube O-ring seals. Lubricate the new O-ring seals with clean engine coolant.
Material: Motorcraft ® Orange Concentrated Antifreeze/Coolant / VC-3-B (WSS-M97B44-D)

GFD41006

Courtesy of FORD MOTOR COMPANY

2.

Install the TC coolant supply tube, then install and tighten the bolt.
Torque: 89 lb.in (10 Nm)

GFD41004

Courtesy of FORD MOTOR COMPANY

3.

Install and tighten the TC coolant supply tube bolt.
Torque: 89 lb.in (10 Nm)

GFD39397

Courtesy of FORD MOTOR COMPANY

4.

Install the air cleaner outlet pipe RH. Refer to: Air Cleaner Outlet Pipe RH .

5.

If equipped, install the skid plate or splash shield, then install and tighten the bolts.
Torque: 30 lb.ft (40 Nm)

GFD40812

Courtesy of FORD MOTOR COMPANY

6.

If equipped, install the transmission housing cover, then install and tighten the retainers.
Torque: 71 lb.in (8 Nm)

GFD38415

Courtesy of FORD MOTOR COMPANY

7.

Install the RHF fender splash shield. Refer to: Fender Splash Shield .

8.

Fill the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .