Oil Pump: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
Prime the oil pump. Add 2 tablespoons of clean engine oil to the oil pump and rotate the oil pump by hand.
- 2.NOTE: Oil pump must be held against the cylinder block until all bolts are tightened.
- Rotate the inner rotor of the oil pump assembly to align the flats on the crankshaft and slip the oil pump over the crankshaft until seated against the block.
- Rotate the oil pump until the bolt holes are aligned to the block and install the fasteners hand tight.
Torque
Stage 1: A: 89 lb.in (10 Nm)
Stage 2: B: 18 lb.ft (25 Nm)
Stage 3: C: 89 lb.in (10 Nm)
Stage 4: D: 177 lb.in (20 Nm)
Stage 5: A: 45 °
Stage 6: B: 75 °
Stage 7: C: 45 °
Stage 8: D: 60 °
- 3.
Using a new O-ring seal, install the oil pump screen and pickup tube and the bolts.Torque:
Oil pump screen and pickup tube-to-oil pump bolts:
Stage 1: 89 lb.in (10 Nm)
Stage 2: 45 °
Oil pump screen and pickup tube-to-spacer bolt : 18 lb.ft (25 Nm)
- 4.
Install the oil pan. Refer to: Oil Pan .
- 6.
Install the timing chains. Refer to: Timing Chain .