LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> F-150 Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine - 5.0L 32V Ti-VCT) >> Removal And Installation >> Oil Cooler >> Removal

Oil Cooler: Removal

WARNING: This page is about a different variant/trim than selected.

  1. 1.

    With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .

  1. 2.

    Remove and discard the engine oil filter.
GFD40409Courtesy of FORD MOTOR COMPANY

  1. 3.

    • Using hose locking pliers, clamp the oil cooler coolant hoses. Use the General Equipment: Locking Pliers
    • Disconnect the coolant hoses.
GFD40519Courtesy of FORD MOTOR COMPANY

  1. 4.

    Remove the retainer and the oil cooler.
GFD40520Courtesy of FORD MOTOR COMPANY

  1. 5.

    Remove and discard the gasket.
GFD40521Courtesy of FORD MOTOR COMPANY

  1. 6.

    NOTE: If metal or aluminum material is present in the oil cooler, mechanical concerns exist. Failure to correct these concerns may cause engine failure. To diagnose mechanical concerns, refer to Engine System - General Information

    Inspect the oil cooler.

GFD40522Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals