Engine Mount RH: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.NOTE: If a new RH engine mount is installed, remove the 2 studs prior to positioning the assembly in the vehicle.
Install the RH engine mount and the new bolts.
Torque: 46 lb.ft (63 Nm)
- 2.
Using the special tool, lower the engine to the installed position. Use Special Service Tool: 303-F070 Support Bar, Engine.
- 3.NOTE: Only use hand tools when installing the engine mount stud bolts or damage to the engine mount can occur.
Install the new RH engine mount stud bolts.
Torque: 22 lb.ft (30 Nm)
- 4.NOTE: Only use hand tools when installing the engine mount nuts or damage to the engine mount can occur.
Install the new RH engine mount nuts.
Torque: 111 lb.ft (150 Nm)
- 5.NOTE: Only use hand tools when tightening the engine mount through bolts or damage to the engine mount-to-cylinder block bracket can occur.
Install the new LH engine mount through bolt.
Torque: 258 lb.ft (350 Nm)
- 6.NOTE: Only use hand tools when installing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.
Tighten the transmission mount-to-crossmember nuts.
Torque: 85 lb.ft (115 Nm)
- 7.
- Position the exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe and install the new bolts.
- Tighten the inner exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolt.
Torque: 46 lb.ft (63 Nm)
- Tighten the outer exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolt.
Torque: 46 lb.ft (63 Nm)
- 8.
Install the following items:- If equipped. Refer to: Front Driveshaft .
- Refer to: Starter Motor .
- 10.
Remove and discard the exhaust manifold nut. Remove Special Service Tool: 303-D099 (D94T-6000-C) Lifting Bracket, Engine.
- 15.
Install the A/C compressor. Refer to: Air Conditioning (A/C) Compressor - 5.0L 32V Ti-VCT .