Cylinder Head LH: Installation
WARNING: This page is about a different variant/trim than selected.
- 2.NOTE: The cylinder head bolts are torque-to-yield and must not be reused. New cylinder head bolts must be installed.
Install the cylinder head and the new bolts.
Torque:
Stage 1: 18 lb.ft (25 Nm)
Stage 2: 55 lb.ft (75 Nm)
Stage 3: Loosen: 180 °
Stage 4: 18 lb.ft (25 Nm)
Stage 5: 26 lb.ft (35 Nm)
Stage 6: 90 °
Stage 7: 90 °
- 5.
Install the following items:- Refer to: Exhaust Manifold LH .
- Refer to: Camshaft LH .
- Refer to: Intake Manifold .
- Refer to: Air Cleaner .
- 6.
- Remove the oil pan drain plug and drain the engine oil. Use the General Equipment: Oil Drain Equipment
- Install the oil pan drain plug.
Torque: 19 lb.ft (26 Nm)
- 8.NOTE: Do not lubricate the O-ring seal.
Install a new oil filter.
Torque:
Stage 1: 44 lb.in (5 Nm)
Stage 2: 180 °
- 9.
Fill the engine with clean engine oil. Refer to: Specifications .Material: Motorcraft ® SAE 5W-20 Premium Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)
- 10.
Connect the battery ground cable. Refer to: Battery Disconnect and Connect .
- 11.
Fill and bleed the engine cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .