LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> F-150 Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine - 5.0L 32V Ti-VCT) >> Removal And Installation >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different variant/trim than selected.

  1. 1.

    Lubricate the seal bore and the seal lips with clean engine oil.

    Material: Motorcraft ® SAE 5W-20 Premium Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)

GFD40392Courtesy of FORD MOTOR COMPANY

  1. 2.

    • Position the special tool onto the end of the crankshaft. Use Special Service Tool: 303-1250 Seal Installer, Rear Main.
    • Slide the new crankshaft rear seal onto the tool.
GFD40393Courtesy of FORD MOTOR COMPANY

  1. 3.

    Using the special tools, install the crankshaft rear seal. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 303-1250 Seal Installer, Rear Main.
GFD40394Courtesy of FORD MOTOR COMPANY

  1. 4.

    Install the crankshaft sensor ring and the engine-to-transmission spacer plate.
GFD40390Courtesy of FORD MOTOR COMPANY

  1. 5.

    Install the flexplate. Refer to: Flexplate .
scientia non olet · About LEMON Manuals