Exhaust Manifold RH: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
- Install the new exhaust manifold studs.
Torque: 106 lb.in (12 Nm)
- Install the new exhaust manifold gasket.
- Install the new exhaust manifold studs.
- 2.NOTE: Failure to tighten the exhaust manifold nuts to specification a second time will cause the exhaust manifold to develop an exhaust leak.
Install the exhaust manifold and the new nuts.
Torque:
Stage 1: 168 lb.in (19 Nm)
Stage 2: 18 lb.ft (25 Nm)
- 3.
Install the RH front wheel and tire Refer to: Wheel and Tire .
- 6.
- Position the exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe and install the new bolts.
- Tighten the inner exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolt.
Torque: 46 lb.ft (63 Nm)
- Tighten the outer exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolt.
Torque: 46 lb.ft (63 Nm)
- 8.
- If equipped, install the underbody shield and bolts.
Torque: 30 lb.ft (40 Nm)
- Install the pin-type retainers.
- If equipped, install the underbody shield and bolts.
- 9.
- If equipped, install the transmission housing cover and attach the retainer.
- Install the bolts.
Torque: 71 lb.in (8 Nm)