Crankshaft Front Seal: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Lubricate the crankshaft front seal bore with clean engine oil.
Material: Motorcraft ® SAE 5W-20 Premium Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)

GFD39582

Courtesy of FORD MOTOR COMPANY

2.

Using the special tools, install the crankshaft front seal. Use Special Service Tool: 303-102 Installer, Crankshaft Pulley., 303-1251 Installer, Front Seal.

GFD39583

Courtesy of FORD MOTOR COMPANY

3.

Lubricate the crankshaft front seal and the crankshaft pulley with clean engine oil.
Material: Motorcraft ® SAE 5W-20 Premium Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)

GFD39584

Courtesy of FORD MOTOR COMPANY

4.

Using the special tools, install the crankshaft pulley. Use Special Service Tool: 303-335 (T88T-6701-A) Installer, Front Cover Oil Seal., 303-102 Installer, Crankshaft Pulley.

GFD39585

Courtesy of FORD MOTOR COMPANY

5.

Using the strap wrench, install the new crankshaft bolt and the washer and tighten in 4 stages. Use the General Equipment: Strap Wrench
Torque:

Stage 1: 89 lb.ft (120 Nm)

Stage 2: Loosen:: 1 turn(s)

Stage 3: 37 lb.ft (50 Nm)

Stage 4: 90 °

GFD39586

Courtesy of FORD MOTOR COMPANY

6.

Install the A/C compressor belt. Refer to: Air Conditioning (A/C) Compressor Belt .

7.

After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure using a diagnostic scan tool.