Valve Cover RH: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.NOTE: Installation of new seals is only required if damaged seals were removed.
Using the special tools, install new spark plug tube seals. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 303-1247 VCT Spark Plug Tube Seal Remover and Installer.
- 3.NOTE: If the valve cover is not installed and the fasteners tightened within 10 minutes, the sealant must be removed and the sealing area cleaned.
Apply an 8 mm (0.31 in) bead of Motorcraft ® High Performance Engine RTV Silicone to the engine front cover-to-cylinder head joints.
Material: Motorcraft ® High Performance Engine RTV Silicone / TA-357 (WSE-M4G323-A6)
- 5.
- Connect the TC vacuum supply hose. Use the General Equipment: Hose Clamp Remover/Installer
- Attach the vacuum hose retainers.
- 6.
Install the RH coil-on-plugs. Refer to: Ignition Coil-On-Plug .
- 7.
- 1.
Install the coolant pipe and the bolts.Torque: 97 lb.in (11 Nm)
- 2.
Connect the coolant hose and clamp. Use the General Equipment: Hose Clamp Remover/Installer
- 1.
- 9.
- 1.
Connect the EOP switch electrical connector.
- 2.
Attach the wiring harness retainers.
- 3.
Position the bracket with heater hose and install the nuts.Torque: 89 lb.in (10 Nm)
- 1.
- 12.
- Install the PCV tube and connect the quick release couplings. Refer to: Quick Release Coupling .
- Connect the throttle body electrical connector and wiring harness retainer.
- 13.
Install the following items:- RH CAC intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
- Refer to: Air Cleaner Outlet Pipe RH .
- 14.
- 1.
Slide the engine appearance cover into the retaining bracket.
- 2.
Install the nuts.Torque: 44 lb.in (5 Nm)
- 1.
- 15.
Fill and bleed the engine cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .