Valve Cover LH: Installation

Using the special tools, install new spark plug tube seals. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 303-1247 VCT Spark Plug Tube Seal Remover and Installer.

Apply an 8 mm (0.31 in) bead of Motorcraft ® High Performance Engine RTV Silicone to the engine front cover-to-cylinder head joints.

Material: Motorcraft ® High Performance Engine RTV Silicone / TA-357 (WSE-M4G323-A6)

Torque: 89 lb.in (10 Nm)

Torque: 89 lb.in (10 Nm)

• 1.
  
  Attach the vacuum hose retainers.

• 2.
  
  Connect the vacuum hose retaining clip.

• 3.
  
  Install the TC control solenoid and the bolts.

  Torque: 62 lb.in (7 Nm)

• 4.
  
  Connect the engine wiring harness electrical connectors.

• 5.
  
  Connect the TC vacuum supply hose.

• 1.
  
  Connect the PCV tube quick release coupling. Refer to: Quick Release Coupling .

• 2.
  
  Connect the crankcase pressure sensor electrical connector.

• 1.
  
  Connect the vacuum tube quick release couplings. Refer to: Quick Release Coupling .

• 2.
  
  Attach the vacuum tube retainer.

• 1.
  
  Position the vacuum harness pressure sensor and install the bolt.

  Torque: 62 lb.in (7 Nm)

• 2.
  
  Connect the MAP sensor electrical connector.

• 3.
  
  Attach the wiring harness and vacuum harness retainers.

Torque: 97 lb.in (11 Nm)

• 1.
  
  Slide the EVAP purge valve onto the intake manifold mounting tab.

• 2.
  
  Connect the EVAP purge valve electrical connector.

• 3.
  
  Connect the EVAP tube quick release coupling. Refer to: Quick Release Coupling .

1. Refer to: Throttle Body .
2. LH CAC intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
3. Refer to: Air Cleaner Outlet Pipe LH .
4. Refer to: Air Cleaner .

• 1.
  
  Slide the engine appearance cover into the retaining bracket.

• 2.
  
  Install the nuts.

  Torque: 44 lb.in (5 Nm)