Oil Pump: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Prime the oil pump. Add 2 tablespoons of clean engine oil to the oil pump and rotate the oil pump by hand.

2.
- 1.
  
  Install the oil pump sprocket into the oil pump drive chain.
- 2.
  
  Raise the rear of the oil pump assembly into the installed position.
- 3.
  
  Install the oil pump bolts.
  Torque:
  
  Stage 1: 89 lb.in (10 Nm)
  
  Stage 2: 45 °

GFD39224

Courtesy of FORD MOTOR COMPANY

3.

Remove the pin.

GFD39225

Courtesy of FORD MOTOR COMPANY

4.

Install the oil pan. Refer to: Oil Pan .