Engine Mount RH: Removal

4x2/4x4 

• 1.
  
  With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .

• 2.
  
  Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect .

• 3.
  
  Remove the following items:
  1. Refer to: Air Cleaner Outlet Pipe RH .
  2. Refer to: Air Cleaner Outlet Pipe LH .
  3. RH CAC intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
  4. Refer to: Charge Air Cooler (CAC) Outlet Pipe .

• 4.
  
  If equipped, remove the fasteners and the underbody shield.

Courtesy of FORD MOTOR COMPANY

• 5.
  
  If equipped, remove the bolts and the skid plate.

Courtesy of FORD MOTOR COMPANY

• 6.
  
  If equipped, remove the fasteners and the underbody shield.

Courtesy of FORD MOTOR COMPANY

• 7.
  
  Remove the following items:
  1. Refer to: Starter Motor .
  2. Refer to: Accessory Drive Belt .

• 8.
  
  

  • 1.
    
    Remove the pin-type retainer.

  • 2.
    
    Remove the bolt and ground wire.

Courtesy of FORD MOTOR COMPANY

• 9.
  
  Remove the following items:
  1. RH wheel and tire. Refer to: Wheel and Tire .
  2. RH fender splash shield. Refer to: Fender Splash Shield .

• 10.
  
  Remove the bolts and position the A/C compressor aside.

Courtesy of FORD MOTOR COMPANY

• 11.
  
  
  NOTE: Make sure that the mating faces are clean and free of foreign material.

  Remove and discard the exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolts and separate.

Courtesy of FORD MOTOR COMPANY

• 12.
  
  
  NOTE: Only use hand tools when removing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.

  Loosen the transmission mount-to-crossmember nuts.

Courtesy of FORD MOTOR COMPANY

4x4 

• 13.
  
  Remove the front drive shaft. Refer to: Front Driveshaft .

4x2 

• 14.
  
  Remove and discard the stabilizer bar bracket nuts.
  • Allow the stabilizer bar to swing downward.

Courtesy of FORD MOTOR COMPANY

4x2/4x4 

• 15.
  
  
  NOTE: Only use hand tools when loosening the engine mount through bolts or damage to the engine mount-to-cylinder block bracket can occur.

  Remove and discard the LH engine mount through bolt.

Courtesy of FORD MOTOR COMPANY

• 16.
  
  
  NOTE: Only use hand tools when removing the engine mount nuts, stud bolts or damage to the engine mount can occur.

  Remove and discard the RH engine mount nuts.

  • Remove the studs.

Courtesy of FORD MOTOR COMPANY

• 17.
  
  

  • 1.
    
    Position an adjustable stand under the rear of the engine. Use the General Equipment: Vehicle/Axle Stands

  • 2.
    
    Raise the engine 50 mm (2 in).

Courtesy of FORD MOTOR COMPANY

• 18.
  
  Remove and discard the engine mount bracket-to-engine bolts.

  • 1.
    
    Remove the engine mount and bracket as an assembly.

  • 2.
    
    Clean the engine mount bracket-to-cylinder block and engine mount-to-frame mating surfaces of any dirt or foreign material prior to installation.

Courtesy of FORD MOTOR COMPANY