Cylinder Head RH: Installation
WARNING: This page is about a different variant/trim than selected.
- 2.
- Install the cylinder head.
- Install new cylinder head bolts.
Torque:
Stage 1: 177 lb.in (20 Nm)
Stage 2: Loosen: 2 turn(s)
Stage 3: 37 lb.ft (50 Nm)
Stage 4: 180 °
- 3.
Install a new fuel rail-to-fuel rail high-pressure fuel tube and finger tighten the flare nuts.- Final tighten the flare nuts.
Torque:
Stage 1: 62 lb.in (7 Nm)
Stage 2: 89 lb.in (10 Nm)
Stage 3: 25 °
- Final tighten the flare nuts.
- 4.
- 1.
Install the cylinder head to coolant outlet connector hose assembly and the bolt.Torque: 89 lb.in (10 Nm)
- 2.
Connect the coolant hose and the clamp. Use the General Equipment: Hose Clamp Remover/Installer
- 1.
- 5.
- 1.
Install the wiring harness ground and the studbolt.Torque: 89 lb.in (10 Nm)
- 2.
Connect the CKP sensor electrical connector.
- 3.
Install the CKP sensor electrical connector insulator.
- 1.
- 6.
Install the following items:- Refer to: Turbocharger RH .
- Refer to: Camshaft RH .
- Refer to: Intake Manifold .
- 7.
Connect the battery ground cable. Refer to: Battery Disconnect and Connect .