Cylinder Head LH: Installation

• Install the cylinder head.

• Install new cylinder head bolts.

  Torque:

  Stage 1: 177 lb.in (20 Nm)

  Stage 2: Loosen: 2 turn(s)

  Stage 3: 37 lb.ft (50 Nm)

  Stage 4: 180 °

• Final tighten the flare nuts.

  Torque:

  Stage 1: 62 lb.in (7 Nm)

  Stage 2: 89 lb.in (10 Nm)

  Stage 3: 25 °

• 1.
  
  Install the cylinder head to coolant outlet connector hose assembly and the bolt.

  Torque: 89 lb.in (10 Nm)

• 2.
  
  Connect the coolant hose and the clamp. Use the General Equipment: Hose Clamp Remover/Installer

Torque: 89 lb.in (10 Nm)

1. Refer to: Turbocharger LH .
2. Refer to: Camshaft LH .
3. Refer to: Intake Manifold .