Coolant Pump: Removal
WARNING: This page is about a different variant/trim than selected.
- 1.
Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .
- 2.
Remove the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe .
- 3.
Remove the CAC outlet pipe. Refer to: Charge Air Cooler (CAC) Outlet Pipe .
- 5.
Remove the accessory drive belt. Refer to: Accessory Drive Belt .
NOTE:
Completely remove the accessory drive belt to prevent coolant contamination.
- 7.
Remove the thermostat. Refer to: Thermostat .
- 8.
Relaese the clamp and disconnect the coolant hose. Use the General Equipment: Hose Clamp Remover/Installer
- 9.NOTE: Use caution to prevent damaging the coolant inlet pipe grommet.
Remove the coolant pump retainers and the coolant pump.
- 10.
- Inspect the coolant pump O-ring and replace if necessary.
-
NOTE: The grommet may remain in the coolant pump housing. If this occurs, remove the grommet from the coolant pump housing.
Remove the grommet from the coolant inlet pipe. Inspect the grommet and replace if necessary.