LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> F-150 Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls System - 2.7L ECOBOOST (238KW/324PS)) >> Removal And Installation >> Knock Sensor (KS) >> Removal

Knock Sensor (KS): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Remove the coolant outlet connector. Refer to: Coolant Outlet Connector .

  1. 2.

    Disconnect the ECT sensor connector, remove retainers and the KS.

    Torque: 97 lb.in (11 Nm)

GFD41203Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals