Engine Oil Pressure (EOP) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan, can cause engine failure.

1.

Remove the following items:
1. RH side only. Refer to: Air Cleaner Outlet Pipe RH . Refer to: Charge Air Cooler (CAC) Intake Pipe .

2.

Disconnect the EOP sensor electrical connector.

Courtesy of FORD MOTOR COMPANY

3.

Remove the EOP sensor.
Torque: 24 lb.ft (33 Nm)

Courtesy of FORD MOTOR COMPANY