LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> F-150 Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls System - 2.7L ECOBOOST (238KW/324PS)) >> Removal And Installation >> Engine Coolant Temperature (ECT) Sensor >> Removal

Engine Coolant Temperature (ECT) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Remove the coolant outlet connector. Refer to: Coolant Outlet Connector .

  1. 2.

    Disconnect the ECT sensor electrical connector.
GFD41191Courtesy of FORD MOTOR COMPANY

  1. 3.

    NOTE: Do not reuse the ECT sensor, install a new sensor.

    Remove and discard the ECT sensor.

    Torque: 142 lb.in (16 Nm)

GFD41192Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals