Cylinder Head Temperature 2 (CHT2) Sensor: Removal
WARNING: This page is about a different variant/trim than selected.
- 1.
Remove the nuts and the engine appearance cover.Torque: 42 lb.in (4.8 Nm)
 Courtesy of FORD MOTOR COMPANY
|
- 2.
Disconnect the CHT2 sensor electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
NOTE:
Do not reuse the CHT2 sensor, install a new sensor.
Remove and discard the CHT2 sensor.
Torque: 106 lb.in (12 Nm)
 Courtesy of FORD MOTOR COMPANY
|