Brake Vacuum Pump - 3.5L EcoBoost (272kW/370PS): Removal

NOTE: Removal steps in this procedure may contain installation details.

• 1.
  
  Remove the oil fill tube cap and the engine appearance cover.

Courtesy of FORD MOTOR COMPANY

• 2.
  
  Remove the RH fender splash shield. Refer to: Fender Splash Shield .

• 3.
  
  Release the coupling and disconnect the vacuum tube.

Courtesy of FORD MOTOR COMPANY

• 4.
  
  
  NOTE: The upper/inboard vacuum pump bolt will remain in the vacuum pump housing when removing the vacuum pump.

  Remove the 3 bolts and the brake vacuum pump.

Courtesy of FORD MOTOR COMPANY