Turbocharger Oil Supply Tube LH: Installation
- 1.
Inspect the spring lock fitting and replace as needed.Torque:
Stage 1: 71 lb.in (8 Nm)
Stage 2: Do not to exceed 26 Nm maximum: 450°
- 2.NOTE: Listen for audible click when installing the oil supply tube into the quick connect fitting.
Connect the turbocharger oil supply tube to the spring lock coupling. REFER to: Spring Lock Couplings .
- 4.
Install and tighten the turbocharger coolant tube bracket nut. Attach the wire harness retainer.Torque
: 71 lb.in (8 Nm)
- 6.
Install the new turbocharger oil supply tube filter and the new turbocharger oil supply tube linked sealing washer.
- 7.
Install the turbocharger oil supply tube and then tighten the new turbocharger oil supply tube bolt.Torque:
Stage 1: 159 lb.in (18 Nm)
Stage 2: 90°
- 8.
Install the turbocharger heat shield, then install and tighten the turbocharger heat shield bolts.Torque
: 106 lb.in (12 Nm)
- 11.
Check and top off the engine oil as needed. REFER to: Specifications .