Turbocharger Oil Supply Tube - RH: Installation
- 1.
Install the new turbocharger oil tube assembly O-ring seal. Lubricate the new turbocharger oil tube assembly O-ring seal with clean engine oil.
- 2.
Inspect the turbocharger oil supply tube-to-engine block fitting and replace as needed. Tighten to 42 Nm (31 lb-ft).
- 3.NOTE: Lubricate the cylinder block bore with clean engine oil.
Install the turbocharger oil tube assembly and install the turbocharger oil tube assembly lower bolt.
- Tighten the turbocharger oil tube assembly lower bolt in the following 2 stages.
- Tighten to 8 Nm (71 lb-in).
- Tighten an additional 30 degrees.
- Tighten the turbocharger oil tube assembly lower bolt in the following 2 stages.
- 4.
Install the Starter Motor, refer to Starting System .
- 5.
Install the Turbocharger - RH, refer to Turbocharger - RH .