Pinpoint Test N : DTCS P0B0D:00, P0C27:00, P0C28:00, P0C29:00, P0C2A:00
- N1 CHECK THE TRANSMISSION FLUID AUXILIARY PUMP POWER CIRCUITS
- Ignition OFF.
- Disconnect Transmission Fluid Auxiliary Pump .
- Ignition ON.
Is the voltage greater than 11 volts?
Yes GO to N2 No VERIFY the BJB fuses 26 (25A) and 38 (5A) are OK. If fuses are OK, REPAIR the affected circuit for an open. If fuses are not OK, REFER to OEM ELECTRICAL WIRING DIAGRAM INTRODUCTION to identify the cause of the affected circuit shorted to ground. - N2 CHECK THE TRANSMISSION FLUID AUXILIARY PUMP GROUND CIRCUIT FOR AN OPEN
Is the resistance less than 3 ohms?
Yes GO to N3 No REPAIR the circuit - N3 CHECK THE TRANSMISSION FLUID LEVEL
- Ignition OFF.
- CHECK the transmission fluid level.
Is the transmission fluid level correct?
Yes If the vehicle is equipped with external lines, hoses going to the transmission fluid auxiliary pump, GO to N5If not equipped with external lines, hoses, GO to N4 No CORRECT the transmission fluid to the proper level. - N4 CHECK THE TRANSMISSION FLUID LINES, HOSES AND COOLER
- Check the transmission fluid lines, hoses and transmission fluid cooler for obstructions or pinches (if equipped).
Are the transmission fluid lines, hoses and transmission fluid cooler free from obstructions or pinches?
Yes GO to N5 No REPAIR as necessary. - N5 CHECK THE TRANSMISSION FLUID AUXILIARY PUMP OPERATION
- Ignition ON.
- Using a diagnostic scan tool, COMMAND the transmission fluid auxiliary pump ON using PID, TRANS_PMP_CMD and vary the duty cycle from 20% to 90%,
Is the transmission fluid auxiliary pump operating and does the pump speed change as the duty cycle is increased or decreased?
Yes GO to N6 No INSTALL a new transmission fluid auxiliary pump. REFER to: Transmission - N6 RECHECK THE TRANSMISSION FLUID AUXILIARY PUMP OPERATION
- Attempt to duplicate concern.
- Clear DTCs and road test vehicle.
Are DTCS P0B0D:00, P0C27:00, P0C28:00, P0C29:00, P0C2A:00, and/or P175A present after the test drive?
Yes INSTALL a new transmission fluid auxiliary pump. REFER to: Transmission No The system is operating correctly at this time.