Transport and Factory Mode Deactivation

Transport and Factory Mode Deactivation 

Deactivation 

• 1.
  
  Place the ignition in the OFF position.

• 2.
  
  Verify the battery is fully charged. REFER to: Battery

• 3.
  
  
  NOTE: On vehicles with Push-Button Start, place a programmed passive key in the PATS backup starting location.

  Place the ignition in the ON position.

• 4.
  
  
  NOTE: Steps 4 and 5 must be carried out within 10 seconds.

  Press and release the brake pedal 5 times.

• 5.
  
  Press and release the hazard switch 2 times (on, off).

• 6.
  
  
  NOTE: When exiting Factory mode, the IPC message center indicates NORMAL MODE when the procedure has been successfully completed.

  Place the ignition in the OFF position.