Wastegate Control Valve Solenoid: Installation

• 1.
  
  Install the wastegate control valve solenoid, then install and tighten the wastegate control valve solenoid retainers. Torque: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR CO.

• 2.
  
  Connect the wastegate control valve solenoid hoses and the wastegate control valve solenoid electrical connector. Use the General Equipment: Hose Clamp Remover/Installer

Courtesy of FORD MOTOR CO.

• 3.
  
  Install the underbody shield and the retainers.

Courtesy of FORD MOTOR COMPANY

• 4.
  
  Install the Powertrain Control Module (PCM). Refer to: Powertrain Control Module (PCM) .