LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> Edge SE, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System - Parking Brake And Actuation >> Diagnosis And Testing >> Parking Brake >> Pinpoint Tests >> Pinpoint Test A : C2005:92, C2006:92 >> Pinpoint Test A : C2005:92, C2006:92

Pinpoint Test A : C2005:92, C2006:92

  1. A1 CHECK ACTUATOR MOTOR OPERATION

    • Make sure the parking brakes are released.
      NOTE: Performing this step sets DTC C2005:74 or C2006:74 in the ABS module.
    • Observe the actuator motor and, using the parking brake switch, apply and release the parking brake.

    Does the actuator motor operate? 

    Yes  GO to  A2
    No  INSTALL a new actuator motor. REFER to: Parking Brake Actuator Motor .

  2. A2 CHECK THE MECHANICAL RESISTANCE

    • Make sure the parking brakes are released.
    • Using a torque wrench, turn the ball screw drive approximately 30 degrees either left or right. Note the amount of torque required to turn the ball screw drive.

    Is the torque required to turn the ball screw drive greater than 5 Nm (44 lb-in)? 

    Yes  INSTALL a new brake caliper. REFER to: Brake Caliper .
    No  INSTALL a new actuator motor. REFER to: Parking Brake Actuator Motor .
scientia non olet · About LEMON Manuals