LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> Edge SE, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Parking Aid System - Vehicles With Parking Aid Camera >> Diagnosis And Testing >> Parking Aid >> Pinpoint Test(s) >> Pinpoint Test N : The Manual Zoom Is Inoperative - Vehicles With Front And Rear Parking Cameras >> Pinpoint Test N : The Manual Zoom Is Inoperative - Vehicles With Front And Rear Parking Cameras

Pinpoint Test N : The Manual Zoom Is Inoperative - Vehicles With Front And Rear Parking Cameras

  1. N1 PERFORM A NETWORK TEST

    • Ignition ON.
    • Using a diagnostic scan tool, perform a network test.

    Do all modules pass the network test? 

    Yes  GO to  N2
    No  REFER to: Communications Network .

  2. N2 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPMB (IMAGE PROCESSING MODULE B) SELF-TEST

    • Using a diagnostic scan tool, perform the IPMB self-test.

    Are any Diagnostic Trouble Codes (DTCs) present? 

    Yes  REFER to the IPMB DTC chart .
    No  GO to  N3

  3. N3 CHECK FOR RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE APIM (SYNC MODULE) SELF-TEST

    • Using a diagnostic scan tool, perform the APIM self-test.

    Are any Diagnostic Trouble Codes present? 

    Yes  For DTC C1001:01, GO to Pinpoint Test A  For all other Diagnostic Trouble Codes (DTCs), Vehicles With: Touchscreen Display REFER to: Information and Entertainment System . Vehicles With: Sony Audio System REFER to: Information and Entertainment System .
    No  GO to  N4

  4. N4 CHECK FOR CORRECT REAR PARKING AID CAMERA OPERATION

    • Ignition OFF.
    • Disconnect and inspect the rear parking aid camera connector and related in-line connectors.
    • Repair:
      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary
    • Reconnect the rear parking aid camera connector and related in-line connectors. Make sure they seat and latch correctly.
    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera .
    No  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals