LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> Edge SE, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Parking Aid System - Vehicles With Parking Aid Camera >> Diagnosis And Testing >> Parking Aid >> DTC Chart(s) >> DTC Chart: BCM

DTC Chart: BCM

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

DTC Description Action
B115E:01 Camera Module: General Electrical Failure GO to Pinpoint Test A 
B115E:02 Camera Module: General Signal Failure GO to Pinpoint Test A 
B115E:08 Camera Module: Bus Signal/Message Failure GO to Pinpoint Test A 
B115E:49 Camera Module: Internal Electronic Failure Sets in continuous memory and on-demand in the BCM when an internal fault in the rear parking aid camera is detected.
CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the BCM self-test.
If DTC B115E:49 returns, INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera .
B115E:55 Camera Module: Not Configured Sets in continuous memory and on-demand in the BCM when the rear parking aid camera is not configured.
PERFORM the rear parking aid camera configuration using a diagnostic scan tool under Electrical>Service Functions>LIN New Module Initialization.
B115E:9A Camera Module: Component or System Operating Conditions Sets as an on-demand DTC in the BCM when the prerequisite conditions are not met for the on-demand self test.
INSPECT the liftgate to make sure it is fully closed and DIAGNOSE any other Diagnostic Trouble Codes (DTCs) present in the BCM. REFER to: Body Control Module (BCM) .
All other Diagnostic Trouble Codes (DTCs) - REFER to: Body Control Module (BCM) .