DTC Chart(s)
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods
IPMB DTC Chart
| DTC | Description | Action |
|---|---|---|
| B115E:08 | Camera Module: Bus Signal/Message Failure | GO to Pinpoint Test A |
| B115E:49 | Camera Module: Internal Electronic Failure | Sets in continuous memory if the IPMB detects an internal fault in the parking aid camera. CLEAR the Diagnostic Trouble Codes (DTCs) and test the system for normal operation. If DTC B115E:49 returns, INSTALL a new parking aid camera. REFER to: Rear Parking Aid Camera |
| B115E:51 | Camera Module: Not Programmed | Sets in continuous memory if the IPMB detects that the parking aid camera is not programmed. Turn the ignition on for 5 minutes to allow the IPMB/camera configuration operation to complete. |
| B115E:54 | Camera Module: Missing Calibration | Sets in continuous memory if the IPMB detects that the parking aid camera is not calibrated. Turn the ignition on for 5 minutes to allow the IPMB/camera configuration operation to complete. |
| B115E:55 | Camera Module: Not Configured | Sets in continuous memory if the IPMB detects that the parking aid camera is not configured. Turn the ignition on for 5 minutes to allow the IPMB/camera configuration operation to complete. |
| U0010:88 | Medium Speed CAN Communication: Bus Off | Sets in continuous memory and on-demand if the IPMB detects a MS-CAN communication fault. The fault is not currently present, as the IPMB had to communicate with the diagnostic scan tool to report this DTC. CHECK the integrity of the IPMB connectors and MS-CAN circuits. Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information. |
| U0137:87 | Lost Communication With Trailer Brake Control Module: Missing Message | GO to Pinpoint Test E |
| U0140:87 | Lost Communication With Body Control Module: Missing Message | GO to Pinpoint Test F |
| U0155:87 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message | GO to Pinpoint Test G |
| U2100:55 | Initial Configuration Not Complete: Not Configured | CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. If there have been recent service actions related to this module, INSTALL As-Built data from Professional Technician Society (PTS), following the diagnostic scan tool instructions under Module Programming>As-Built. If there have been no recent service actions related to this module, INSTALL a new IPMB to correct the failure to retain configuration data. |
| U3006:16 | Control Module Input Power "A": Circuit Voltage Below Threshold | GO to Pinpoint Test H |
| U3006:17 | Control Module Input Power "A": Circuit Voltage Above Threshold | GO to Pinpoint Test I |
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods
APIM DTC Chart
| DTC | Description | Action |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | GO to Pinpoint Test A |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Information and Entertainment System - Vehicles With: AM/FM/CD/SYNC/Touchscreen Display |
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods
FCDIM DTC Chart
| DTC | Description | Action |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | GO to Pinpoint Test A |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Information and Entertainment System - Vehicles With: AM/FM/CD/SYNC |