Network Message Chart

Module Network Input Messages - IPC

Broadcast Message	Originating Module	Message Purpose
Adaptive cruise control warning request	CCM	Input used to control the adaptive cruise control warning chime.
Brake pedal applied	PCM	Input used to control the PRNDL not in park warning chime.
Cross traffic alert left status	SODL	Input used to control the BLIS ®/CTA warning chime.
Cross traffic alert right status	SODR	Input used to control the BLIS ®/CTA warning chime.
Cruise control status	PCM	Input used to control the adaptive cruise control warning chime.
Driver door ajar status	BCM	Input used to control the igntion-engine on warning chime and the PRNDL not in park warning chime.
Driver safety belt buckle status	RCM	Input used to control the safety belt warning chime and the Belt-Minder ®.
Engine status	PCM	Input used to control the ignition-engine on warning chime.
Forward collision chime request	CCM	Input used to control the forward collision warning chime.
Front passenger detect status	RCM	Input used to control the Belt-Minder ®.
Gear lever position	PCM	Input used to control the Belt-Minder ®. Reverse input on automatic transmissions used for the backup chime (Japan only).
Headlamp on warning chime	BCM	Input used to control the headlamp on warning chime.
Ignition status	BCM	Input used for the following: To provide ignition RUN, START and ACC states. To control the PRNDL not in park warning chime.
Key-in-ignition indicator status	BCM	Input used to control the key-in-ignition warning chime.
Left turn lamp request	BCM	Input used to control the turn signal-hazard tick-tock tone chime.
Memory feedback request	DSM	Input used to control the memory feedback confirmation chime.
Parking aid chime request	PAM	Input used to control the parking aid chime.
Parking brake chime request	BCM	Input used to control the parking brake warning chime.
Passenger safety belt buckle status	RCM	Input used to control the Belt-Minder ®.
Perimeter alarm chime request	BCM	Input used to control the perimeter alarm chime.
Reverse gear state	PCM	Reverse input on manual transmissions used for the backup chime (Japan only).
Right turn lamp request	BCM	Input used to control the turn signal-hazard tick-tock tone chime.
Side obstacle sensor status-left	SODL	Input used to control the BLIS ®/CTA warning chime.
Side obstacle sensor status-right	SODR	Input used to control the BLIS ®/CTA warning chime.
Stability-traction control chime request	ABS module	Input used to control the service AdvanceTrac ® warning chime.
Transmission gear display mode	PCM	Input used to control the ignition-engine on warning chime and the PRNDL not in park warning chime.
Turn signal status	SCCM	Input used to control the turn signal left on warning chime.
Vehicle speed	PCM	Input used to control the Belt-Minder ®, PRNDL not in park warning chime.

Module Network Input Messages - ACM and DSP Module

Broadcast Message	Originating Module	Message Purpose
Chime source	IPC	Input used to configure the chime source (IPC or the audio system).
Cross Traffic Alert (CTA) chime request	IPC	Input from the IPC used to control the Cross Traffic Alert (CTA) audio chime output.
IPC chime request	IPC	Input from the IPC used to control the audio chime output.
MyKey Belt-Minder ® audio mute	IPC	Input from the IPC used to mute the audio for the Belt-Minder ® chime.
Power up chime modules	IPC	Input used to initiate the audio system as the chime source.