Network Message Chart
Module Network Input Messages - IPC
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| ABS fault | ABS module | ABS input used to display the check brake system warning message. |
| Adaptive cruise control warning request | CCM | Input used to display the adaptive cruise control message display. |
| Battery low state of charge | BCM | Input used to control the charging system RTT and the charging system fault message center warning message. |
| Body service required request | BCM | BCM controlled system faults input used to control the powertrain malfunction (wrench) RTT. |
| Brake fluid level low message request | BCM | Input used to display the low brake fluid level warning message. |
| Brake wear message request | VDM | Input used to display the ceramic brakes-replace front brake pads warning message (SVT only). |
| Convertible top message request | Moveable Roof Control Module-A (MRCMA) | Input used to display the convertible top messages. |
| Cross traffic alert left status | SODL | Input used to control the Blind Spot Monitoring (BLIS ®)/Cross Traffic Alert (CTA) message display. |
| Cross traffic alert right status | SODR | Input used to control the Blind Spot Monitoring (BLIS ®)/Cross Traffic Alert (CTA) message display. |
| Cruise control override | PCM | Input used to control the cruise control RTT. |
| Cruise control set speed display | PCM | Input used to control the cruise control set speed display. |
| Cruise control status | PCM | Input used to control the cruise control RTT. |
| Driver door ajar status | BCM | Input used to control the following: Door ajar RTT. Driver door ajar message center warning message. Engine on warning message. Transmission not in park warning message. |
| Engine coolant temperature data | PCM | Used to control the engine over-temperature RTT and the engine over-temperature message center warning message. |
| Engine idle shutdown status | PCM | Input used to control the automatic engine shutdown message display. |
| Engine oil life | PCM | Input used to display the engine oil life and oil change messages. |
| Engine overheat indication request | PCM | Used to control the engine over-temperature RTT and the engine over-temperature message center warning message. |
| Engine RPM data | PCM | Input used to control the low oil pressure RTT, the low oil pressure message center warning message and the Average Fuel Economy (AFE)/ DTE display. |
| Engine service required request | PCM | Engine input used to control the powertrain malfunction (wrench) RTT. |
| Engine status | PCM | Input used to display the engine on warning message and the Average Fuel Economy (AFE)/DTE display. |
| EPAS Failure | PSCM | Input used to display the EPAS messages. |
| Forward collision warning message request | CCM | Input used to display the forward collision warning messages. |
| Fuel fill inlet message display | PCM | Input used to display the check fuel fill inlet message. |
| Fuel flow volume display | PCM | Input used to display the Average Fuel Economy (AFE)/DTE. |
| GPS compass direction | GPSM | Input used to display the vehicle compass heading. |
| Hill start assist status | ABS module | Input used to control the hill start assist not available message. |
| Ignition key type | BCM | Input used to display the Average Fuel Economy (AFE)/DTE. |
| Ignition status | BCM | Input used for the following: To provide ignition RUN, START and ACC states. To display the transmission not in park warning message. To display the odometer. |
| Immobilizer message display | BCM | Input used to display the PATS, passive entry and key programming messages. |
| Lock system message request | BCM | Input used to display the child lock, key battery low and security mode messages. |
| Luggage compartment lid ajar | BCM | Input used to control the door ajar RTT and the luggage compartment lid ajar message center warning message. |
| Odometer count | PCM | Input used to display the Average Fuel Economy (AFE)/DTE and odometer. |
| Oil pressure warning indicator request | PCM | Input used to control the low oil pressure RTT and the low oil pressure message center warning message. |
| Parking aid fault status | PAM | Input used to display the check parking aid message. |
| Parking aid rear status | PAM | Input used to display the parking aid on/off status message. |
| Parking brake status | BCM | Input used to display the parking brake applied warning message. |
| Passenger door ajar status | BCM | Input used to control the door ajar RTT and the passenger door ajar message center warning message. |
| Perimeter alarm chime request | BCM | Input used to display the start vehicle to stop alarm message. |
| Power shed level request | BCM | Input used to display the load shed messages. |
| Powertrain drive mode | PCM | Input used to control the following drive mode Reconfigurable Telltales (RTT's): Drag strip (SVT) Launch control (SVT) Normal drive Sport Snow/wet (non-SVT) Track (non-SVT) Weather (SVT) |
| Remote start status | BCM | Input used to display the remote start messages. |
| Seat memory command | DSM | Input used to display the memory seat operational messages. |
| Side obstacle detect status-left | SODL | Input used to control the Blind Spot Monitoring (BLIS ®) off RTT and message display. |
| Side obstacle detect status-right | SODR | Input used to control the Blind Spot Monitoring (BLIS ®) off RTT and message display. |
| Stability-traction control chime request | ABS module | Input used to display the service AdvanceTrac ® message. |
| Starting system fault message request | PCM | Input used to display starting system messages. |
| Steering effort status | PSCM | Input used to control the steering mode RTT. |
| Suspension driver mode status | VDM | Input used to control the vehicle dynamics (damper control) RTT. |
| Tire pressure system status | BCM | Input used to display the TPMS fault and tire training messages. |
| Transmission gear display mode | PCM | Input used to display the engine on warning message and transmission not in park warning message. |
| Transmission service required | PCM | Transmission input used to control the powertrain malfunction (wrench) RTT. |
| Transport mode | BCM | Input used to display the factory and transport mode message and not in park warning message. |
| Trip odometer verify | PCM | Input used to display the trip odometer. |
| Vehicle configuration data | BCM | Input used to display the odometer and the tire mobility kit expiration message. |
| Vehicle dynamics SOS | ABS module | Input used to display the spin out detected message. |
| Vehicle speed | PCM | Input used for the following displays: Average Fuel Economy (AFE)/DTE display. Digital speed display. Engine on warning message. Not in park warning message. Overspeed warning RTT (Gulf Cooperative Countries [GCC]) |
Module Network Input Messages - PCM
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Engine oil life data reset | IPC | Input used to request the oil life minder reset. |