LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2015 >> Fusion Titanium, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Steering Column Electrical Components (Except Hybrid/ENERGI) >> Removal And Installation >> Heated Steering Wheel Module (HSWM) >> Removal

Heated Steering Wheel Module (HSWM): Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    NOTE: This step is only necessary when installing a new component.
    NOTE: The PMI process must begin with the current HSWM installed. If the current HSWM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

    Using a diagnostic scan tool, begin the PMI process for the HSWM following the on-screen instructions.

  1. 2.

    Remove the driver knee airbag. Refer to: Driver Knee Airbag .

  1. 3.

    Position the steering column in the full forward/down position.
GFD66800Courtesy of FORD MOTOR COMPANY

  1. 4.

    • Disconnect the electrical connector.
    • Remove the bolts and the HSWM.

      Torque: 22 lb.in (2.5 Nm)

GFD66801Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals