Symptom Chart(s)
Symptom Chart: Turn Signal and Hazard Lamps
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods
Symptom Chart
| Condition | Possible Sources | Actions |
|---|---|---|
| A module does not respond to the scan tool | Fuse Wiring, terminals or connectors Module |
REFER to: Communications Network |
| The turn signal function is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test A |
| The turn signal function is always on | Multifunction switch SCCM |
INSTALL a new LH steering column multifunction switch. REFER to: Steering Column Multifunction Switch LH TEST the system for normal operation. If the concern still exists, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) |
| One turn signal lamp is inoperative or always on | Refer to the Pinpoint Test | GO to Pinpoint Test B |
| The hazard lamp function is inoperative or always on | Refer to the Pinpoint Test | GO to Pinpoint Test C |