Valve Cover: Removal

WARNING: This page is about a different car, the 2016 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

1.

Refer to: Air Cleaner Outlet Pipe . Refer to: Air Cleaner .

2.

GFD70839

Courtesy of FORD MOTOR COMPANY

3.

GFD70873

Courtesy of FORD MOTOR COMPANY

4.

GFD70874

Courtesy of FORD MOTOR COMPANY

5.

GFD70875

Courtesy of FORD MOTOR COMPANY

6.

Refer to: Ignition Coil-On-Plug .

7.

Refer to: Quick Release Coupling .

GFD70876

Courtesy of FORD MOTOR COMPANY

8.

GFD70877

Courtesy of FORD MOTOR COMPANY

9.

GFD70878

Courtesy of FORD MOTOR COMPANY

10.

GFD70879

Courtesy of FORD MOTOR COMPANY

11.

GFD70880

Courtesy of FORD MOTOR COMPANY

12.

GFD70881

Courtesy of FORD MOTOR COMPANY

13.

GFD70882

Courtesy of FORD MOTOR COMPANY

14.

GFD70883

Courtesy of FORD MOTOR COMPANY

15.

GFD70884

Courtesy of FORD MOTOR COMPANY

16.

GFD70885

Courtesy of FORD MOTOR COMPANY

17.

GFD70886

Courtesy of FORD MOTOR COMPANY

18.

NOTE: The VCT solenoid seal should only be replaced if it is damaged.

Use Special Service Tool: 303-1247 VCT Spark Plug Tube Seal Remover and Installer., 205-153 (T80T-4000-W) Handle.

GFD70887

Courtesy of FORD MOTOR COMPANY

19.

NOTE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths.

Clean the sealing surfaces.

Material: Motorcraft ® Metal Surface Prep Wipes / ZC-31-B