Glove Compartment: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- 1.WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in the General Information article. Failure to follow this instruction may result in serious personal injury.
Refer to: Health and Safety Precautions
- 2.
Release the clips and remove the RH instrument panel side trim panel. Use the General Equipment: Interior Trim Remover
- 3.
Release the clips and remove the RH instrument panel finish panel. Use the General Equipment: Interior Trim Remover
- 4.
Remove the bolts, release the retaining tabs and remove the glove compartment. Disconnect the electrical connector.Torque
: 22 lb.in (2.5 Nm)