Pinpoint Test AP : The Active Park Assist/Parking Aid Chime Is Inoperative
WARNING: This page is about a different car, the 2016 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- AP1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver safety belt.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
Yes GO to AP2 No Refer to IPC Hardware Testing . - AP2 VERIFY THE CHIMES FUNCTION THROUGH THE AUDIO SPEAKERS
- Ignition OFF.
- Ignition ON.
- Monitor the location of the safety belt warning chime (front/rear audio speakers or IPC) when the ignition is transitioned from OFF to RUN.
Does the chime sound through the audio speakers?
Yes GO to AP4 No GO to AP3 - AP3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network - 2.0L Duratec - Hybrid (96kW/130PS) . No GO to AP4 - AP4 PERFORM THE PARKING AID MODULE (PAM) SELF-TEST
- Using a diagnostic scan tool, perform the Parking Aid Module (PAM) self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Parking Aid . Refer to: Parking Aid - Active Park Assist . No GO to AP5 - AP5 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: IPC . No DIAGNOSE the audible parking aid. Refer to: Parking Aid . Refer to: Parking Aid - Active Park Assist .