LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2015 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes (Hybrid/ENERGI) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes - 2.0L Duratec - Hybrid (96kW 130PS) >> Pinpoint Tests >> Pinpoint Test BV : U3003:17 >> Pinpoint Test BV : U3003:17

Pinpoint Test BV : U3003:17

  1. BV1 CHECK VOLTAGE AT THE BATTERY

    • Start the vehicle (Ready indicator light ON).
    • Turn off the headlamps, blower and any other accessories.
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      GFD70561Courtesy of FORD MOTOR COMPANY

    Is the voltage less than 16 volts? 

    Yes  GO to  BV2
    No  DIAGNOSE the overcharging condition. For PHEV, REFER to: DIRECT CURRENT DIRECT CURRENT (DC DC) CONVERTER CONTROL MODULE - PLUG-IN HYBRID ELECTRIC VEHICLE (PHEV) . If the battery condition fails, INSTALL a new battery. REFER to: Battery

  2. BV2 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U3003:17

    • Ignition OFF.
    • Ignition ON.
    • Using a diagnostic scan tool, clear the continuous memory DTCs.
    • Carry out the IPC self-test.

    Is DTC U3003:17 present? 

    Yes  Refer to IPC Hardware Testing .
    No  The system is operating correctly at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals