LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2015 >> Fusion Energi Titanium >> Repair and Diagnosis >> External Pages >> Different car >> Section 624 (Engine Cooling System - 2.0L DURATEC - Hybrid (96KW/130PS) (Hybrid/ENERGI)) >> Removal And Installation >> Cooling Fan Motor and Shroud >> Removal

Cooling Fan Motor and Shroud: Removal

WARNING: This page is about a different car, the 2016 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    WARNING: Before beginning any service procedure, refer to Safety Warnings in General Information. Failure to follow this instruction may result in serious personal injury.

    Refer to: Engine Cooling System Health and Safety Precautions .

  1. 2.

    Refer to: Cooling System Draining, Filling and Bleeding .

  1. 3.

    Use the General Equipment: Hose Clamp Remover/Installer
GFD71088Courtesy of FORD MOTOR COMPANY

  1. 4.

    Torque: 53 lb.in (6 Nm)
GFD71089Courtesy of FORD MOTOR COMPANY

  1. 5.

    NOTE: Support the radiator/condenser/cooling fan motor and shroud assembly.

    Torque: 18 lb.ft (24 Nm)

GFD71090Courtesy of FORD MOTOR COMPANY

  1. 6.

GFD71091Courtesy of FORD MOTOR COMPANY

  1. 7.

    Torque: 53 lb.in (6 Nm)
GFD71092Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals