LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2015 >> Fusion Energi Titanium >> Repair and Diagnosis >> External Pages >> Different car >> Section 1012 (Parking Brake System - Parking Brake Actuation (Except Hybrid)) >> Removal And Installation >> Parking Brake Switch >> Removal

Parking Brake Switch: Removal

WARNING: This page is about a different car, the 2017 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Open the floor console stowage bin lid.
    GFD190520Courtesy of FORD MOTOR COMPANY
  2. On both sides. Detach the clips and remove the floor console upper side finish panels.
    GFD190521Courtesy of FORD MOTOR COMPANY
  3. Detach the clips and remove the instrument panel center finish panel.
    GFD190522Courtesy of FORD MOTOR COMPANY
  4. Remove the screws, detach the clips and remove the upper floor console finish panel.
    GFD190523Courtesy of FORD MOTOR COMPANY
    1. Remove the screws.
    2. Detach the clips and position the floor console upper support to access the parking brake switch.
    3. Disconnect the electrical connector.
    4. Remove the parking brake switch.
GFD190524Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals