Pinpoint Test Ab : The Headlamps On Warning Chime Is Inoperative

AB1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?

Yes GO to AB2

No GO to Pinpoint Test A

AB2 CHECK THE INTERIOR LAMPS OPERATION
- Open and close the driver door.
- Observe the interior lamps.
Do the interior lamps operate correctly from the driver door?

Yes GO to AB3

No REFER to: Interior Lighting .

AB3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

Using a scan tool, perform the IPC self-test.

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes	For DTC U0140:00, GO to Pinpoint Test BF For DTC U0151:00, v For all other Diagnostic Trouble Codes (DTCs), REFER to DTC Chart: IPC .

No

GO to AB4

AB4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to: Body Control Module (BCM) .

No INSTALL a new BCM. Refer to: Body Control Module (BCM) .