| Air ambient temperature filtered actual |
PCM |
Input used to provide the outside air temperature display. |
| BLIS system status |
SODL |
Input used to display the BLIS status and fault messages. |
| Brake fluid level low |
BCM |
Input used to display the low brake fluid level warning message. |
| Brake warning request |
BCM |
Input used to display the brake system malfunction warning message. |
| Bulb failure indication |
BCM |
Input used to display a bulb failure message. |
| Compass display data |
BCM |
Input used to provide the compass display. |
| Cruise control status |
PCM |
Input used to control the cruise control message center indicator. |
| Door status |
BCM |
Input used to display the individual door ajar warning messages. |
| Econometer |
PCM |
Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. |
| EPAS display |
PSCM |
Input used to display the service power steering message. |
| Engine coolant temperature |
PCM |
Input used to display the engine over-temperature message. |
| Engine MIL request |
PCM |
Input used to display the engine malfunction message. |
| Engine service indication |
PCM |
Input used to provide the change oil service message display. |
| Hill start assist status |
ABS module |
Input used to provide the hill start assist message display. |
| Ignition status |
BCM |
Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting. |
| Key warning indication |
BCM |
Used to display the key not inside vehicle message (keyless entry only). |
| Lane keeping system hands off display |
IPMA |
Used to display the hands off steering wheel warning message. |
| Parking aid active |
Parking Aid Module (PAM) |
Input used to display the parking aid malfunction and service required messages. |
| Parking aid disable status |
Parking Aid Module (PAM) |
Input used to display the parking aid cannot be disabled message for MyKey ®. |
| Parking brake warning request |
BCM |
Input used to display the parking brake applied message. |
| Passive entry/start indication |
BCM |
Input used to display the press brake to start message (push button start only). |
| PATS indication |
BCM |
Input used to display the immobilizer active message for the PATS. |
| Passive key status |
RFA module |
Used to display the passive key left inside vehicle message and the key not in vehicle message (keyless entry only). |
| Power system status |
BCM |
Input used to display the charging system warning messages. |
| Tire pressure indication |
BCM |
Input used to display the TPMS malfunction warning messages and the TPMS tire sensor training messages. |
| Transport mode |
BCM |
Input used to provide the vehicle in transport mode display. |
| Transmission gear display actual |
TCM |
Input used to display the turn ignition off message (keyless entry only). |
| Transmission message request |
RFA |
Input used to display transmission related messages and the transmission not in park message. |
| Transmission service required |
TCM |
Input used to display the transmission malfunction messages. |
| Transmission upshift indication request |
PCM |
Input used to control the upshift message center indicator. |
| Washer fluid level low |
BCM |
Input used to display the low washer fluid message. |
| Wheel rotation count front |
ABS module |
Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. |